[NJairheads] Push rod seals and protective push rod stainless steel tube

[William Dudley]

I don't know, but Mike Kowal can give you knowledgable advice.

His cell is: 732 239 8541

Bill Dudley

This email is free of malware because I run Linux.


On Sat, Apr 27, 2019 at 4:11 PM George Rand via NJairheads <
njairheads at casano.com> wrote:

> I am in the middle of replacing my push rod seals on R75/5 1971 engine.
> Disassembly was straight forward and no big issues.
> When I pulled the heads away from the engine push rod seals were exposed.
> On the exhaust side, the protective push rod tube was broken at the
> bottom.   A piece of the tubing was stuck into my rubber push rod seal!
> I want to replace the tube, what is the procedure  to get the old tube out
> of the head?
>
>
> Skip Rand
> gprjr62 at gmail.com <mailto:gprjr62 at gmail.com>
> 609-417-5807
> R75/5
> R1150R
>
>
>
>
> _______________________________________________
> NJairheads mailing list
> NJairheads at casano.com
> https://mailman.dudley.nu/mailman/listinfo/njairheads
>