electrical guru needed

[Zwicky, Eric]

Wow, this sounds a lot like what I'm doing.   Mine's an '80, but sat 
under a tarp for five years.   I'm stripping it to the frame and am 
planning on complete new EME harnesses.   I have an Enduralast III 
charging system on the way, still trying to decide on the ignition.   I 
have the EDL III and crank-mounted EME ignition on my /6 and the 
ignition I'm not 100% crazy about.  So I might go with Rick Jones' Alpha 
v3 points-in-a-can replacement.

So the EME stock repro harnesses might need to be modified.

TLDR version:

I will be watching your progress with considerable interest.

Eric Z
RVa



On 5/16/2021 12:33 PM, Porter Gieske via MDAirheads wrote:
> Greetings, folks-
> I am in the midst of rewiring my 82 R100RS, now just S, with a set of EME components, and I was wondering if anyone would be interested in helping me walk through my setup to provide insights on a proper wiring.
> And by walking through this, I mean virtually, over email or text or video, just to run down the list of what is connected to what.
> 
> The previous owner’s outdoor storage was not kind to the many connectors and rubber bits, so the 'why did I do this?' is because most of the electrical was corroded and not working well.
> 
> I have already installed:
> EME enduralast 400w charging system, diode board and stator, with connections.
> EME optical ignition sensor
> EME voltage reg/rec
> EME ignition control module
> EME 3k ohm single coil tower - that’s a single unit with 2 spark plug leads, as they said it was best for my setup.
> 
> I am using an M-Unit as the hub for things, it works fine in testing.
> I am using the M-Button too, that also functions as it should.  I saw the turn signals in the rear to flash from the handle bar control switches, so that was progress.
> 
> Where I am getting confusion/conflict is the wiring between the starter motor, the coils and the regulator, with the battery in there, of course.
> 
> I have found stock wiring diagrams of little use here.  I have found a few similar setups to mine, however they aren’t as helpful in real life.
> 
> I am using the stock starter.
> 
> My next step on this is to phone EME, and ask them for help, it wouldn’t surprise me if they had diagrams ready to send, and yes, I have looked on their site.
> 
> I am open to suggestions on how to best tackle this and Thanks!
> porter
> 
> 
>